Rinse and soak the rope for 15 – 20 minutes in a separate tub with clean water and Downy® fabric softener.Run the rope twice through a rope washer (Bokat or equal) – repeat more times if the rope is exceptionally dirty.Use the ratio indicated by the product manufacturer. Soak the rope for approximately 30 minutes in a tub of warm water and mild detergent that is safe for nylon and polyester (Woolite® or equal). Rinse off any excess dirt using clean water from a hose.CMC recommends the following washing procedures. After the equipment has been cleaned, remember to re-label it as necessary and enter the date, cleaning method, and inspection data into a log. CleaningĪll rope rescue and access equipment should be kept clean and free of dirt and grit to prevent wear that will reduce the strength, effectiveness, and service life. Inspect equipment carefully and give strong consideration to replacement. We define cleaning as removing dirt, grime, and minor oxidation transfer while decontaminating is intended to neutralize viruses, bacteria, and other pathogens.Īlways refer to department guidelines and regulatory guidance for best practices. CMC is issuing the following updated recommendations on how to clean and decontaminate life safety equipment.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |